Stinky Pinky™ is designed to remove rust stains from delicate surfaces where other rust removers cannot be used due to their corrosive, acidic, nature.  It has a neutral pH which allows for a wide range of uses on many different substrates and will remove oxidisation from marble, stone, wood, paint, fibreglass, concrete, limestone and more.

Stinky Pinky™ is a non-acidic rust remover which converts rust compounds into a water soluble solution. It changes colour on activation and contact with rust. It is designed to remove rust stains from delicate surfaces where other rust removers cannot be used due to their corrosive and acidic nature.

Coverage rates

Coverage of GK Stinky Pinky depends on the porosity of the substrate. The values by substrate below are given only as an indication:

  • Architectural Concrete: 5m² per litre
  • Block Paving: 5-8m² per litre
  • Natural Stone: 2-5m² per litre
  • Granite: 8-16m² per litre

Aplication

  • Do not dilute, product is ready to use
  • Always carry out an initial test to ensure the finished result is acceptable 
  • Before application remove grease, dirt, all loose and flaking material.
  • Apply a saturated coat by brush or spray at a rate of 3m² - 4m² per litre on absorbent and 8m² - 10m² for non absorbent surfaces (such as tile or porcelain).
  • Leave Stinky Pinky™ to react: Light staining – for 10 minutes, Heavy staining – for up to 2 hours
  • Do not allow the product to dry. Re-apply if the surface dries out.
  • Rinse thoroughly with clean water and leave to dry


Back To Top